1.2. Preparation for eServer OpenPower, p5, and i5

The eServer OpenPower, p5, and i5 systems introduce many options for partitioning, virtual or native devices, and consoles. All three versions of the system use the same kernel and have many of the same options available, depending on the system configuration.

If you are using a non-partitioned OpenPower or p5 system, you do not need any pre-installation setup. For systems using the HVSI serial console, hook up your console to the T2 serial port.

If using a partitioned system, whether OpenPower, p5, or i5, the steps to create the partition and start the installation are largely the same. You should create the partition at the HMC and assign some CPU and memory resources, as well as SCSI and Ethernet resources, which can be either virtual or native. The HMC create partition wizard steps you through the creation.

For more information on creating the partition, refer to IBM's Infocenter article on Configuring Linux logical partitions available online at:

http://publib.boulder.ibm.com/infocenter/eserver/v1r2s/en_US/
 index.htm?info/iphbi/iphbiconfig.htm

Note that due to the length of this URL, it has been broken into two lines.

If you are using virtual SCSI resources, rather than native SCSI, you must configure a 'link' to the virtual SCSI serving partition, and then configure the virtual SCSI serving partition itself. You create a 'link' between the virtual SCSI client and server slots using the HMC. You can configure a virtual SCSI server on either AIX or i5/OS, depending on which model and options you have.

For more information on these topics, refer to IBM's Infocenter article, Creating a Linux logical partition using i5/OS virtual I/O resources available online at:

http://publib.boulder.ibm.com/infocenter/eserver/v1r2s/en_US/
 index.htm?info/iphbl/iphblioserverpartition.htm

Note that due to the length of this URL, it has been broken into two lines.

NoteNote
 

Additional Information on virtualization eServer i5 and p5 can be found in the Redbooks SG24-6388-00 and SG24-7940-00, Linux on IBM eServer i5 Implementation Guide and Introduction to Advanced POWER Virtualization on IBM eServer p5 Servers. These can be accessed from http://www.redbooks.ibm.com/ and searching on the book number.

Once you have your system configured, you need to Activate from the HMC or power it on. Depending on what type of install you are doing, you may need to configure SMS to correctly boot the system into the installation program.