Sometimes there isn't a network connection (e.g. DSL modem is down), or we want to multicast only on the local machine. For this the loopback interface (typically lo) can be configured, e.g. route add -net 224.0.0.0 netmask 224.0.0.0 dev lo. This means that all traffic directed to the 224.0.0.0 network will be sent to the loopback interface, which means it doesn't need any network to be running. Note that the 224.0.0.0 network is a placeholder for all multicast addresses in most UNIX implementations: it will catch all multicast traffic. This is an undocumented feature of /sbin/route and may not work across all UNIX flavors. The above instructions may also work for Windows systems, but this hasn't been tested. Note that not all systems allow multicast traffic to use the loopback interface.
Typical home networks have a gateway/firewall with 2 NICs: the first (eth0) is connected to the outside world (Internet Service Provider), the second (eth1) to the internal network, with the gateway firewalling/masquerading traffic between the internal and external networks. If no route for multicast traffic is added, the default will be to use the fdefault gateway, which will typically direct the multicast traffic towards the ISP. To prevent this (e.g. ISP drops multicast traffic, or latency is too high), we recommend to add a route for multicast traffic which goes to the internal network (e.g. eth1).