raw — bind a Linux raw character device
raw /dev/raw/raw<N>
<major> <minor>
raw /dev/raw/raw<N>
/dev/<blockdev>
raw −q /dev/raw/raw<N>
raw −qa
raw is used to bind a Linux raw character device to a block device. Any block device may be used: at the time of binding, the device driver does not even have to be accessible (it may be loaded on demand as a kernel module later).
raw is used
in two modes: it either sets raw device bindings, or it
queries existing bindings. When setting a raw device,
/dev/raw/raw<N>
is the device name of an existing raw device node in the
filesystem. The block device to which it is to be bound can
be specified either in terms of its major and minor device numbers, or as a
path name /dev/<blockdev> to an
existing block device file.
The bindings already in existence can be queried with the
−q option, with is used
either with a raw device filename to query that one device,
or with the −a option to
query all bound raw devices.
Unbinding can be done by specifying major and minor 0.
Once bound to a block device, a raw device can be opened, read and written, just like the block device it is bound to. However, the raw device does not behave exactly like the block device. In particular, access to the raw device bypasses the kernel's block buffer cache entirely: all I/O is done directly to and from the address space of the process performing the I/O. If the underlying block device driver can support DMA, then no data copying at all is required to complete the I/O.
Because raw I/O involves direct hardware access to a process's memory, a few extra restrictions must be observed. All I/Os must be correctly aligned in memory and on disk: they must start at a sector offset on disk, they must be an exact number of sectors long, and the data buffer in virtual memory must also be aligned to a multiple of the sector size. The sector size is 512 bytes for most devices.
−qSet query mode. raw will query an existing binding instead of setting a new one.
−aWith −q , specifies that
all bound raw devices should be queried.
−hprovides a usage summary.
The Linux dd (1) command should be used without bs= option or the blocksize needs to be a multiple of the sector size of the device (512 bytes usually) otherwise it will fail with "Invalid Argument" messages (EINVAL).
Raw I/O devices do not maintain cache coherency with the Linux block device buffer cache. If you use raw I/O to overwrite data already in the buffer cache, the buffer cache will no longer correspond to the contents of the actual storage device underneath. This is deliberate, but is regarded either a bug or a feature depending on who you ask!