Configure options

• --with-tokyo-tyrant[=DIR] DIR is the prefix to the Tokyo Tyrant installation
• --with-tokyo-cabinet-dir[=DIR] DIR is the prefix to the Tokyo Cabinet installation
• --disable-tokyo-tyrant-session Disable Tokyo Tyrant session handler support

Enabling the extension

The extension can be enabled by adding extension=tokyo_tyrant.so to the INI-configuration

Running Tokyo Tyrant for the session handler

ttserver -port 2000 -ext /path/to/expire.lua -extpc expire 30.0 '/tmp/sessions.tct#idx=ts:dec'

Informacja: expire.lua is included in the tokyo_tyrant extension source distribution

Configuring session handler

• tokyo_tyrant.session_salt="randomlongstring"
• session.save_handler=tokyo_tyrant
• session.save_path="tcp://hostname1:2000,tcp://hostname2:2000"

Informacja: It is important to make sure that tokyo_tyrant.session_salt matches on all servers.

How it works?

The session handler creates a session id like the following: 8b0e27a823fa4a6cf7246945b82c1d51-a5eadbbed1f2075952900628456bfd6830541629-0-5460

The parts from left to right:

• Session id - Generated session id
• Checksum - Checksum of session salt, session id, node id and primary key
• Node id - The id of the node where the session maps to
• Primary key - The primary key of the row where the session is stored

The checksum contains SHA1 sum of the node id, primary key, session id and the salt which is known only on the server side. This allows quick mapping of session id to node and primary key since there is no need to do an additional search. During session id regeneration only the parts 1 and 2 change but the mapping to the node and primary key stays constant.

In case some of the nodes fail tokyo_tyrant.allow_failover, tokyo_tyrant.fail_threshold and tokyo_tyrant.health_check_divisor INI-settings control the behavior during failover. If failover is allowed the session handler will map the session to a healthy node and creates a new empty session.