tcdevices — Shorewall Traffic Shaping Devices file
/etc/shorewall/tcdevices
Entries in this file define the bandwidth for interfaces on which you want traffic shaping to be enabled.
If you do not plan to use traffic shaping for a device, don't put it in here as it limits the troughput of that device to the limits you set here.
A note on the bandwidth definitions used in this file:
don't use a space between the integer value and the unit: 30kbit is valid while 30 kbit is not.
you can use one of the following units:
Kilobytes per second.
Megabytes per second.
Kilobits per second.
Megabits per second.
Bytes per second.
Only whole integers are allowed.
The columns in the file are as follows.
Name of interface. Each interface may be listed only once in this file. You may NOT specify the name of an alias (e.g., eth0:0) here; see http://www.shorewall.net/FAQ.htm#faq18
You may NOT specify wildcards here, e.g. if you have multiple ppp interfaces, you need to put them all in here!
If the device doesn't exist, a warning message will be issued during "shorewall [re]start" and "shorewall refresh" and traffic shaping configuration will be skipped for that device.
The incoming bandwidth of that interface. Please note that you are not able to do traffic shaping on incoming traffic, as the traffic is already received before you could do so. But this allows you to define the maximum traffic allowed for this interface in total, if the rate is exceeded, the packets are dropped. You want this mainly if you have a DSL or Cable connection to avoid queuing at your providers side.
If you don't want any traffic to be dropped, set this to a value to zero in which case Shorewall will not create an ingress qdisc.
The outgoing bandwidth of that interface. This is the maximum speed your connection can handle. It is also the speed you can refer as "full" if you define the tc classes in shorewall-tcclasses(5). Outgoing traffic above this rate will be dropped.
This file is currently limited to ten (10) entries. Additional entries will cause run-time errors in the generated firewall script.
Suppose you are using PPP over Ethernet (DSL) and ppp0 is the interface for this. The device has an outgoing bandwidth of 500kbit and an incoming bandwidth of 6000kbit
#INTERFACE IN-BANDWIDTH OUT-BANDWIDTH
ppp0 6000kbit 500kbithttp://shorewall.net/traffic_shaping.htm
shorewall(8), shorewall-accounting(5), shorewall-actions(5), shorewall-blacklist(5), shorewall-hosts(5), shorewall-interfaces(5), shorewall-ipsec(5), shorewall-maclist(5), shorewall-masq(5), shorewall-nat(5), shorewall-netmap(5), shorewall-params(5), shorewall-policy(5), shorewall-providers(5), shorewall-proxyarp(5), shorewall-route_rules(5), shorewall-routestopped(5), shorewall-rules(5), shorewall.conf(5), shorewall-tcclasses(5), shorewall-tcrules(5), shorewall-tos(5), shorewall-tunnels(5), shorewall-zones(5)