Samba/SMB

Tom Eastep

Permission is granted to copy, distribute and/or modify this document under the terms of the GNU Free Documentation License, Version 1.2 or any later version published by the Free Software Foundation; with no Invariant Sections, with no Front-Cover, and with no Back-Cover Texts. A copy of the license is included in the section entitled “GNU Free Documentation License”.

2007/07/19



Caution

This article applies to Shorewall 3.0 and later. If you are running a version of Shorewall earlier than Shorewall 3.0.0 then please see the documentation for that release.

If you wish to run Samba on your firewall and access shares between the firewall and local hosts, you need the following rules:

#ACTION   SOURCE   DEST   PROTO    DEST PORT(S)   SOURCE
#                                                 PORT(S)
SMB/ACCEPT  $FW      loc
SMB/ACCEPT  loc      $FW

To pass traffic SMB/Samba traffic between zones Z1 and Z2:

#ACTION   SOURCE   DEST   PROTO    DEST PORT(S)   SOURCE
#                                                 PORT(S)
SMB/ACCEPT  Z1       Z2
SMB/ACCEPT  Z2       Z1

To make network browsing (“Network Neighborhood”) work properly between Z1 and Z2 requires a Windows Domain Controller and/or a WINS server. I have run Samba on my firewall to handle browsing between two zones connected to my firewall.

When debugging Samba/SMB problems, I recommend that you do the following:

  1. Copy action.Drop and action.Reject from /usr/share/shorewall to /etc/shorewall.

  2. Edit the copies and remove the SMB/DROP and SMB/REJECT lines.

  3. shorewall restart

The above steps will cause SMB traffic that is dropped or rejected by policy to be logged rather than handled silently.

If you are using Windows XP™ to test your setup,make you sure you have a properly configured client firewall .

You can just remove the copies and shorewall restart when you are finished debugging.