routestopped — The Shorewall file that governs what traffic flows through the firewall while it is in the 'stopped' state.
/etc/shorewall/routestopped
This file is used to define the hosts that are accessible when the firewall is stopped or is being stopped.
Changes to this file do not take effect until after the next shorewall start or shorewall restart command.
The columns in the file are as follows.
Interface through which host(s) communicate with the firewall
Comma-separated list of IP/subnet addresses. If your kernel and iptables include iprange match support, IP address ranges are also allowed.
If left empty or supplied as "-", 0.0.0.0/0 is assumed.
A comma-separated list of options. The order of the options is not important but the list can contain no embedded whitespace. The currently-supported options are:
Set up a rule to ACCEPT traffic from these hosts back to themselves. Beginning with Shorewall 4.4.9, this option is automatically set if routeback is specified in shorewall-interfaces (5) or if the rules compiler detects that the interface is a bridge.
Allow traffic from these hosts to ANY destination. Without this option or the dest option, only traffic from this host to other listed hosts (and the firewall) is allowed. If source is specified then routeback is redundant.
Allow traffic to these hosts from ANY source. Without this option or the source option, only traffic from this host to other listed hosts (and the firewall) is allowed. If dest is specified then routeback is redundant.
The traffic will be exempted from conntection tracking.
protocol-name-or-number
Protocol.
service-name/port-number-list
A comma-separated list of port numbers and/or service names
from /etc/services
. May also include port
ranges of the form
low-port
:high-port
if your kernel and iptables include port range support.
service-name/port-number-list
A comma-separated list of port numbers and/or service names
from /etc/services
. May also include port
ranges of the form
low-port
:high-port
if your kernel and iptables include port range support.
The source and dest options work best when used in conjunction with ADMINISABSENTMINDED=Yes in shorewall.conf(5).
#INTERFACE HOST(S) OPTIONS PROTO DEST SOURCE # PORT(S) PORT(S) eth2 192.168.1.0/24 eth0 192.0.2.44 br0 - routeback eth3 - source eth4 - notrack 41
http://shorewall.net/starting_and_stopping_shorewall.htm
shorewall(8), shorewall-accounting(5), shorewall-actions(5), shorewall-blacklist(5), shorewall-hosts(5), shorewall-interfaces(5), shorewall-ipsec(5), shorewall-maclist(5), shorewall-masq(5), shorewall-nat(5), shorewall-netmap(5), shorewall-params(5), shorewall-policy(5), shorewall-providers(5), shorewall-proxyarp(5), shorewall-route_rules(5), shorewall-rules(5), shorewall.conf(5), shorewall-tcclasses(5), shorewall-tcdevices(5), shorewall-tcrules(5), shorewall-tos(5), shorewall-tunnels(5), shorewall-zones(5)