Supported Hardware

Ubuntu does not impose hardware requirements beyond the requirements of the Linux kernel and the GNU tool-sets. Therefore, any architecture or platform to which the Linux kernel, libc, gcc, etc. have been ported, and for which an Ubuntu port exists, can run Ubuntu.

Rather than attempting to describe all the different hardware configurations which are supported for IA-64, this section contains general information and pointers to where additional information can be found.

Supported Architectures

Ubuntu 9.04 supports three major architectures and several variations of each architecture known as flavors. Three other architectures (HP PA-RISC, Intel ia64, and IBM/Motorola PowerPC) have unofficial ports.

Architecture Ubuntu Designation Subarchitecture Flavor
Intel x86-based i386    
AMD64 & Intel EM64T amd64    
HP PA-RISC hppa PA-RISC 1.1 32
PA-RISC 2.0 64
Intel IA-64 ia64    
IBM/Motorola PowerPC powerpc PowerMac pmac
Sun SPARC sparc sun4u sparc64
sun4v    

Multiple Processors

Multiprocessor support — also called symmetric multiprocessing or SMP — is available for this architecture. However, the standard Ubuntu 9.04 kernel image does not support SMP. This should not prevent installation, since the standard, non-SMP kernel should boot on SMP systems; the kernel will simply use the first CPU.

In order to take advantage of multiple processors, you'll have to replace the standard Ubuntu kernel. You can find a discussion of how to do this in the section called “Compiling a New Kernel”. At this time (kernel version 2.6.28) the way you enable SMP is to select SMP support in the General setup section of the kernel config.

Graphics Card Support

Ubuntu's support for graphical interfaces is determined by the underlying support found in X.Org's X11 system. Most AGP, PCI and PCIe video cards work under X.Org. Details on supported graphics buses, cards, monitors, and pointing devices can be found at http://xorg.freedesktop.org/. Ubuntu 9.04 ships with X.Org version 7.3.

Network Connectivity Hardware

Almost any network interface card (NIC) supported by the Linux kernel should also be supported by the installation system; modular drivers should normally be loaded automatically.

Peripherals and Other Hardware

Linux supports a large variety of hardware devices such as mice, printers, scanners, PCMCIA and USB devices. However, most of these devices are not required while installing the system.