Version: 5.4 beta (switch to 5.3)
Audio Reverb Filter
Audio Effects

Audio Chorus Filter

Switch to Scripting

The Audio Chorus Filter takes an Audio Clip and processes it creating a chorus effect.

Properties

Property: Function:
Dry Mix Volume of original signal to pass to output. 0.0 to 1.0. Default = 0.5.
Wet Mix 1 Volume of 1st chorus tap. 0.0 to 1.0. Default = 0.5.
Wet Mix 2 Volume of 2nd chorus tap. This tap is 90 degrees out of phase of the first tap. 0.0 to 1.0. Default = 0.5.
Wet Mix 3 Volume of 3rd chorus tap. This tap is 90 degrees out of phase of the second tap. 0.0 to 1.0. Default = 0.5.
Delay The LFO’s delay in ms. 0.1 to 100.0. Default = 40.0 ms
Rate The LFO’s modulation rate in Hz. 0.0 to 20.0. Default = 0.8 Hz.
Depth Chorus modulation depth. 0.0 to 1.0. Default = 0.03.
Feed Back Chorus feedback. Controls how much of the wet signal gets fed back into the filter’s buffer. 0.0 to 1.0. Default = 0.0.

Details

The chorus effect modulates the original sound by a sinusoid low frequency oscillator (LFO). The output sounds like there are multiple sources emitting the same sound with slight variations - resembling a choir.

You can tweak the chorus filter to create a flanger effect by lowering the feedback and decreasing the delay, as the flanger is a variant of the chorus.

Creating a simple, dry echo is done by setting Rate and Depth to 0 and tweaking the mixes and Delay

Audio Reverb Filter
Audio Effects