Installing the software to your system consists of copying the compiled
programs and supporting files to a standard location. After the
installation process has completed, these files have been copied
from your work directory to /usr/local/bin, and /usr/local/etc.
To install the Zebra suite, issue the following command at your shell
prompt: make install.
%
% make install
%
Zebra daemons have their own terminal interface or VTY. After
installation, you have to setup each beast's port number to connect to
them. Please add the following entries to /etc/services.
zebrasrv 2600/tcp # zebra service
zebra 2601/tcp # zebra vty
ripd 2602/tcp # RIPd vty
ripngd 2603/tcp # RIPngd vty
ospfd 2604/tcp # OSPFd vty
bgpd 2605/tcp # BGPd vty
ospf6d 2606/tcp # OSPF6d vty
If you use a FreeBSD newer than 2.2.8, the above entries are already
added to /etc/services so there is no need to add it. If you
specify a port number when starting the daemon, these entries may not be
needed.
You may need to make changes to the config files in
/usr/local/etc/*.conf. See Config Commands.