Add/Remove OSDs¶

Adding and removing Ceph OSD Daemons to your cluster may involve a few more steps when compared to adding and removing other Ceph daemons. Ceph OSD Daemons write data to the disk and to journals. So you need to provide a disk for the OSD and a path to the journal partition (i.e., this is the most common configuration, but you may configure your system to your own needs).

In Ceph v0.60 and later releases, Ceph supports dm-crypt on disk encryption. You may specify the --dmcrypt argument when preparing an OSD to tell ceph-deploy that you want to use encryption. You may also specify the --dmcrypt-key-dir argument to specify the location of dm-crypt encryption keys.

You should test various drive configurations to gauge their throughput before before building out a large cluster. See Data Storage for additional details.

List Disks¶

To list the disks on a node, execute the following command:

ceph-deploy disk list {node-name [node-name]...}

Zap Disks¶

To zap a disk (delete its partition table) in preparation for use with Ceph, execute the following:

ceph-deploy disk zap {osd-server-name}:{disk-name}
ceph-deploy disk zap osdserver1:sdb

Important

This will delete all data.

Prepare OSDs¶

Once you create a cluster, install Ceph packages, and gather keys, you may prepare the OSDs and deploy them to the OSD node(s). If you need to identify a disk or zap it prior to preparing it for use as an OSD, see List Disks and Zap Disks.

ceph-deploy osd prepare {node-name}:{data-disk}[:{journal-disk}]
ceph-deploy osd prepare osdserver1:sdb:/dev/ssd
ceph-deploy osd prepare osdserver1:sdc:/dev/ssd

The prepare command only prepares the OSD. On most operating systems, the activate phase will automatically run when the partitions are created on the disk (using Ceph udev rules). If not use the activate command. See Activate OSDs for details.

The foregoing example assumes a disk dedicated to one Ceph OSD Daemon, and a path to an SSD journal partition. We recommend storing the journal on a separate drive to maximize throughput. You may dedicate a single drive for the journal too (which may be expensive) or place the journal on the same disk as the OSD (not recommended as it impairs performance). In the foregoing example we store the journal on a partitioned solid state drive.

Note

When running multiple Ceph OSD daemons on a single node, and sharing a partioned journal with each OSD daemon, you should consider the entire node the minimum failure domain for CRUSH purposes, because if the SSD drive fails, all of the Ceph OSD daemons that journal to it will fail too.

Activate OSDs¶

Once you prepare an OSD you may activate it with the following command.

ceph-deploy osd activate {node-name}:{data-disk-partition}[:{journal-disk-partition}]
ceph-deploy osd activate osdserver1:/dev/sdb1:/dev/ssd1
ceph-deploy osd activate osdserver1:/dev/sdc1:/dev/ssd2

The activate command will cause your OSD to come up and be placed in the cluster. The activate command uses the path to the partition created when running the prepare command.

Create OSDs¶

You may prepare OSDs, deploy them to the OSD node(s) and activate them in one step with the create command. The create command is a convenience method for executing the prepare and activate command sequentially.

ceph-deploy osd create {node-name}:{disk}[:{path/to/journal}]
ceph-deploy osd create osdserver1:sdb:/dev/ssd1

Destroy OSDs¶

Note

Coming soon. See Remove OSDs for manual procedures.

Navigation