| [ < ] | [ > ] | [ << ] | [ Up ] | [ >> ] | [Top] | [Contents] | [Index] | [ ? ] |
The following options can be used to configure the sound modules. The default values are stored in `CS/data/config/sound.cfg'.
These options apply to all sound renderers:
Sound.Volume = [0..1]Set the global volume. A value of 0 means silence, 1 means as loud as possible. Default is 1.
These options only apply to the software sound renderer:
Sound.Software.Frequency = <frequency>This sets the output frequency. Possible values depend on your system and sound card, but divisors of 44100 (e.g. 22050 or 11025) usually work. Default is 44100 (optimal).
Sound.Software.16Bits = <yes/no>Enables 16 bit sound output. Default is yes.
Sound.Software.Stereo = <yes/no>Enables stereo sound output. Default is yes.
These options only apply to the Wave-Out sound driver under Windows:
Sound.WaveOut.Refresh = <rate>Sets the refresh rate of the sound output as a per-second rate. The lower this rate, the more time passes between your application starting to play a sound and the sound actually being audible. Because the Wave-Out driver uses a triple buffering system, this delay is 2 to 3 seconds divided by the refresh rate. So you should set a rate of at least 10 to prevent serious delays. Default is 5.
| [ < ] | [ > ] | [ << ] | [ Up ] | [ >> ] |
This document was generated using texi2html 1.76.