midway.h

Go to the documentation of this file.

/* drivers/atm/midway.h - Efficient Networks Midway (SAR) description */
 
/* Written 1995-1999 by Werner Almesberger, EPFL LRC/ICA */
 

#ifndef DRIVERS_ATM_MIDWAY_H
#define DRIVERS_ATM_MIDWAY_H


#define NR_VCI      1024        /* number of VCIs */
#define NR_VCI_LD   10      /* log2(NR_VCI) */
#define NR_DMA_RX   512     /* RX DMA queue entries */
#define NR_DMA_TX   512     /* TX DMA queue entries */
#define NR_SERVICE  NR_VCI      /* service list size */
#define NR_CHAN     8       /* number of TX channels */
#define TS_CLOCK    25000000    /* traffic shaper clock (cell/sec) */

#define MAP_MAX_SIZE    0x00400000  /* memory window for max config */
#define EPROM_SIZE  0x00010000
#define MEM_VALID   0xffc00000  /* mask base address with this */
#define PHY_BASE    0x00020000  /* offset of PHY register are */
#define REG_BASE    0x00040000  /* offset of Midway register area */
#define RAM_BASE    0x00200000  /* offset of RAM area */
#define RAM_INCREMENT   0x00020000  /* probe for RAM every 128kB */

#define MID_VCI_BASE    RAM_BASE
#define MID_DMA_RX_BASE (MID_VCI_BASE+NR_VCI*16)
#define MID_DMA_TX_BASE (MID_DMA_RX_BASE+NR_DMA_RX*8)
#define MID_SERVICE_BASE (MID_DMA_TX_BASE+NR_DMA_TX*8)
#define MID_FREE_BASE   (MID_SERVICE_BASE+NR_SERVICE*4)

#define MAC_LEN 6 /* atm.h */

#define MID_MIN_BUF_SIZE (1024)     /*   1 kB is minimum */
#define MID_MAX_BUF_SIZE (128*1024) /* 128 kB is maximum */

#define RX_DESCR_SIZE   1       /* RX PDU descr is 1 longword */
#define TX_DESCR_SIZE   2       /* TX PDU descr is 2 longwords */
#define AAL5_TRAILER    (ATM_AAL5_TRAILER/4) /* AAL5 trailer is 2 longwords */

#define TX_GAP      8       /* TX buffer gap (words) */

/*
 * Midway Reset/ID
 *
 * All values read-only. Writing to this register resets Midway chip.
 */

#define MID_RES_ID_MCON 0x00        /* Midway Reset/ID */

#define MID_ID      0xf0000000  /* Midway version */
#define MID_SHIFT   24
#define MID_MOTHER_ID   0x00000700  /* mother board id */
#define MID_MOTHER_SHIFT 8
#define MID_CON_TI  0x00000080  /* 0: normal ctrl; 1: SABRE */
#define MID_CON_SUNI    0x00000040  /* 0: UTOPIA; 1: SUNI */
#define MID_CON_V6  0x00000020  /* 0: non-pipel UTOPIA (required iff
                       !CON_SUNI; 1: UTOPIA */
#define DAUGTHER_ID 0x0000001f  /* daugther board id */

/*
 * Interrupt Status Acknowledge, Interrupt Status & Interrupt Enable
 */

#define MID_ISA     0x01        /* Interrupt Status Acknowledge */
#define MID_IS      0x02        /* Interrupt Status */
#define MID_IE      0x03        /* Interrupt Enable */

#define MID_TX_COMPLETE_7 0x00010000    /* channel N completed a PDU */
#define MID_TX_COMPLETE_6 0x00008000    /* transmission */
#define MID_TX_COMPLETE_5 0x00004000
#define MID_TX_COMPLETE_4 0x00002000
#define MID_TX_COMPLETE_3 0x00001000
#define MID_TX_COMPLETE_2 0x00000800
#define MID_TX_COMPLETE_1 0x00000400
#define MID_TX_COMPLETE_0 0x00000200
#define MID_TX_COMPLETE 0x0001fe00  /* any TX */
#define MID_TX_DMA_OVFL 0x00000100  /* DMA to adapter overflow */
#define MID_TX_IDENT_MISM 0x00000080    /* TX: ident mismatch => halted */
#define MID_DMA_LERR_ACK 0x00000040 /* LERR - SBus ? */
#define MID_DMA_ERR_ACK 0x00000020  /* DMA error */
#define MID_RX_DMA_COMPLETE 0x00000010  /* DMA to host done */
#define MID_TX_DMA_COMPLETE 0x00000008  /* DMA from host done */
#define MID_SERVICE 0x00000004  /* something in service list */
#define MID_SUNI_INT    0x00000002  /* interrupt from SUNI */
#define MID_STAT_OVFL   0x00000001  /* statistics overflow */

/*
 * Master Control/Status
 */

#define MID_MC_S    0x04

#define MID_INT_SELECT  0x000001C0  /* Interrupt level (000: off) */
#define MID_INT_SEL_SHIFT 6
#define MID_TX_LOCK_MODE 0x00000020 /* 0: streaming; 1: TX ovfl->lock */
#define MID_DMA_ENABLE  0x00000010  /* R: 0: disable; 1: enable
                       W: 0: no change; 1: enable */
#define MID_TX_ENABLE   0x00000008  /* R: 0: TX disabled; 1: enabled
                       W: 0: no change; 1: enable */
#define MID_RX_ENABLE   0x00000004  /* like TX */
#define MID_WAIT_1MS    0x00000002  /* R: 0: timer not running; 1: running
                       W: 0: no change; 1: no interrupts
                                   for 1 ms */
#define MID_WAIT_500US  0x00000001  /* like WAIT_1MS, but 0.5 ms */

/*
 * Statistics
 *
 * Cleared when reading.
 */

#define MID_STAT        0x05

#define MID_VCI_TRASH   0xFFFF0000  /* trashed cells because of VCI mode */
#define MID_VCI_TRASH_SHIFT 16
#define MID_OVFL_TRASH  0x0000FFFF  /* trashed cells because of overflow */

/*
 * Address registers
 */

#define MID_SERV_WRITE  0x06    /* free pos in service area (R, 10 bits) */
#define MID_DMA_ADDR    0x07    /* virtual DMA address (R, 32 bits) */
#define MID_DMA_WR_RX   0x08    /* (RW, 9 bits) */
#define MID_DMA_RD_RX   0x09
#define MID_DMA_WR_TX   0x0A
#define MID_DMA_RD_TX   0x0B

/*
 * Transmit Place Registers (0x10+4*channel)
 */

#define MID_TX_PLACE(c) (0x10+4*(c))

#define MID_SIZE    0x00003800  /* size, N*256 x 32 bit */
#define MID_SIZE_SHIFT  11
#define MID_LOCATION    0x000007FF  /* location in adapter memory (word) */

#define MID_LOC_SKIP    8       /* 8 bits of location are always zero
                       (applies to all uses of location) */

/*
 * Transmit ReadPtr Registers (0x11+4*channel)
 */

#define MID_TX_RDPTR(c) (0x11+4*(c))

#define MID_READ_PTR    0x00007FFF  /* next word for PHY */

/*
 * Transmit DescrStart Registers (0x12+4*channel)
 */

#define MID_TX_DESCRSTART(c) (0x12+4*(c))

#define MID_DESCR_START 0x00007FFF  /* seg buffer being DMAed */

#define ENI155_MAGIC    0xa54b872d

struct midway_eprom {
    unsigned char mac[MAC_LEN],inv_mac[MAC_LEN];
    unsigned char pad[36];
    u32 serial,inv_serial;
    u32 magic,inv_magic;
};


/*
 * VCI table entry
 */

#define MID_VCI_IN_SERVICE  0x00000001  /* set if VCI is currently in
                           service list */
#define MID_VCI_SIZE        0x00038000  /* reassembly buffer size,
                           2*<size> kB */
#define MID_VCI_SIZE_SHIFT  15
#define MID_VCI_LOCATION    0x1ffc0000  /* buffer location */
#define MID_VCI_LOCATION_SHIFT  18
#define MID_VCI_PTI_MODE    0x20000000  /* 0: trash, 1: preserve */
#define MID_VCI_MODE        0xc0000000
#define MID_VCI_MODE_SHIFT  30
#define MID_VCI_READ        0x00007fff
#define MID_VCI_READ_SHIFT  0
#define MID_VCI_DESCR       0x7fff0000
#define MID_VCI_DESCR_SHIFT 16
#define MID_VCI_COUNT       0x000007ff
#define MID_VCI_COUNT_SHIFT 0
#define MID_VCI_STATE       0x0000c000
#define MID_VCI_STATE_SHIFT 14
#define MID_VCI_WRITE       0x7fff0000
#define MID_VCI_WRITE_SHIFT 16

#define MID_MODE_TRASH  0
#define MID_MODE_RAW    1
#define MID_MODE_AAL5   2

/*
 * Reassembly buffer descriptor
 */

#define MID_RED_COUNT       0x000007ff
#define MID_RED_CRC_ERR     0x00000800
#define MID_RED_T       0x00001000
#define MID_RED_CE      0x00010000
#define MID_RED_CLP     0x01000000
#define MID_RED_IDEN        0xfe000000
#define MID_RED_SHIFT       25

#define MID_RED_RX_ID       0x1b        /* constant identifier */

/*
 * Segmentation buffer descriptor
 */

#define MID_SEG_COUNT       MID_RED_COUNT
#define MID_SEG_RATE        0x01f80000
#define MID_SEG_RATE_SHIFT  19
#define MID_SEG_PR      0x06000000
#define MID_SEG_PR_SHIFT    25
#define MID_SEG_AAL5        0x08000000
#define MID_SEG_ID      0xf0000000
#define MID_SEG_ID_SHIFT    28
#define MID_SEG_MAX_RATE    63

#define MID_SEG_CLP     0x00000001
#define MID_SEG_PTI     0x0000000e
#define MID_SEG_PTI_SHIFT   1
#define MID_SEG_VCI     0x00003ff0
#define MID_SEG_VCI_SHIFT   4

#define MID_SEG_TX_ID       0xb     /* constant identifier */

/*
 * DMA entry
 */

#define MID_DMA_COUNT       0xffff0000
#define MID_DMA_COUNT_SHIFT 16
#define MID_DMA_END     0x00000020
#define MID_DMA_TYPE        0x0000000f

#define MID_DT_JK   0x3
#define MID_DT_WORD 0x0
#define MID_DT_2W   0x7
#define MID_DT_4W   0x4
#define MID_DT_8W   0x5
#define MID_DT_16W  0x6
#define MID_DT_2WM  0xf
#define MID_DT_4WM  0xc
#define MID_DT_8WM  0xd
#define MID_DT_16WM 0xe

/* only for RX*/
#define MID_DMA_VCI     0x0000ffc0
#define MID_DMA_VCI_SHIFT   6

/* only for TX */
#define MID_DMA_CHAN        0x000001c0
#define MID_DMA_CHAN_SHIFT  6

#define MID_DT_BYTE 0x1
#define MID_DT_HWORD    0x2

#endif