qt_set_finalizer_mode

Customizes aspects of a target's finalization.

This command was introduced in Qt 6.2.

Synopsis

qt_set_finalizer_mode(target
    ENABLE | DISABLE
    MODES modes...
)

If versionless commands are disabled, use qt6_set_finalizer_mode() instead. It supports the same set of arguments as this command.

Description

This command is used to customize some aspects of the finalization of a specific target. It only has an effect if called before target is finalized, which occurs in one of the following scenarios:

• The project explicitly calls qt_finalize_target() for the target. This usually means the MANUAL_FINALIZATION keyword was passed to qt_add_executable() when the target was defined.
• CMake 3.17 or earlier is being used, in which case finalization always occurs immediately as part of the call to qt_add_executable().
• CMake 3.18 or later is being used, the MANUAL_FINALIZATION keyword was not passed to qt_add_executable() when the target was defined, and deferred finalization has been completed at the end of the target's directory scope.

qt_set_finalizer_mode() is used to enable or disable a list of modes, where a mode corresponds to a specific aspect of finalization. The currently supported finalization modes are:

Example

The following example assumes you are using CMake 3.19 or later (required for deferred finalization):

qt_add_executable(my_app main.cpp)
qt_set_finalizer_mode(my_app ENABLE MODES static_plugins)

The same example using manual finalization might look like this:

qt_add_executable(my_app MANUAL_FINALIZATION main.cpp)
qt_set_finalizer_mode(my_app ENABLE MODES static_plugins)
qt_finalize_target(my_app)