Network Configuration

If you have a network card and have not already configured your networking information, you now have the opportunity to configure networking (as shown in Figure 4-10).

	Please Note
	If your system has more than one Ethernet card, please make sure you configure both cards. Select the card by clicking on the device name tab.

Choose your device type and whether you would like to configure using DHCP. If you have multiple Ethernet devices, each device will keep the information you have provided. You may switch between devices, for example eth0 and eth1, and the information you give will be specific to each device. If you select Activate on boot, your network interface will be started when you boot. If you do not have DHCP client access or are unsure as to what this information is, please contact your network administrator.

Next enter, where applicable, the IP Address, Netmask, Network, and Broadcast addresses. If you are unsure about any of these, please contact your network administrator.

	Tip
	Even if your computer is not part of a network, you can enter a hostname for your system. Take this opportunity to enter in a name, if you do not, your system will be known as localhost.

Finally, enter the Gateway and Primary DNS (and if applicable the Secondary DNS and Ternary DNS) addresses.