4.10. Starting the Cluster Software

4.10. Starting the Cluster Software

4.10. Starting the Cluster Software

After you have propagated the cluster configuration to the cluster nodes you can either reboot each node or start the cluster software on each cluster node by running the following commands at each node in this order:

  1. service cman start

  2. service clvmd start

  3. service gfs start, if you are using Red Hat GFS

  4. service rgmanager start

  5. Start the Red Hat Cluster Suite management GUI. At the Cluster Configuration Tool tab, verify that the configuration is correct. At the Cluster Status Tool tab verify that the nodes and services are running as expected.