| Package | flash.display |
| Class | public final class GraphicsPathCommand |
| Inheritance | GraphicsPathCommand  Object |
The values in this class are used by the Graphics.drawPath() method,
or stored in the commands vector of a GraphicsPath object.
See also
| Constant | Defined By | ||
|---|---|---|---|
| CURVE_TO : int = 3 [static]
Specifies a drawing command that draws a curve from the current drawing position to the x- and y-coordinates
specified in the data vector, using a control point. | GraphicsPathCommand | ||
| LINE_TO : int = 2 [static]
Specifies a drawing command that draws a line from the current drawing position to the x- and y-coordinates
specified in the data vector. | GraphicsPathCommand | ||
| MOVE_TO : int = 1 [static]
Specifies a drawing command that moves the current drawing position to the x- and y-coordinates specified in the data vector. | GraphicsPathCommand | ||
| NO_OP : int = 0 [static]
Represents the default "do nothing" command. | GraphicsPathCommand | ||
| WIDE_LINE_TO : int = 5 [static]
Specifies a "line to" drawing command, but uses two sets of coordinates (four values) instead of one set. | GraphicsPathCommand | ||
| WIDE_MOVE_TO : int = 4 [static]
Specifies a "move to" drawing command, but uses two sets of coordinates (four values) instead of one set. | GraphicsPathCommand | ||
| CURVE_TO | Constant |
Hide Inherited Public Properties
Show Inherited Public Properties
public static const CURVE_TO:int = 3
Specifies a drawing command that draws a curve from the current drawing position to the x- and y-coordinates
specified in the data vector, using a control point.
This command produces the same effect as the Graphics.lineTo() method, and
uses two points in the data vector control and anchor: (cx, cy, ax, ay ).
See also
| LINE_TO | Constant |
public static const LINE_TO:int = 2
Specifies a drawing command that draws a line from the current drawing position to the x- and y-coordinates
specified in the data vector.
This command produces the same effect as the Graphics.lineTo() method, and
uses one point in the data vector: (x,y).
See also
| MOVE_TO | Constant |
public static const MOVE_TO:int = 1
Specifies a drawing command that moves the current drawing position to the x- and y-coordinates specified in the data vector.
This command produces the same effect as the Graphics.moveTo() method, and
uses one point in the data vector: (x,y).
See also
| NO_OP | Constant |
public static const NO_OP:int = 0Represents the default "do nothing" command.
| WIDE_LINE_TO | Constant |
public static const WIDE_LINE_TO:int = 5Specifies a "line to" drawing command, but uses two sets of coordinates (four values) instead of one set. This command allows you to switch between "line to" and "curve to" commands without changing the number of data values used per command. This command uses two sets in the data vector: one dummy location and one (x,y) location.
The WIDE_LINE_TO and WIDE_MOVE_TO command variants consume the same number of parameters
as does the CURVE_TO command.
See also
| WIDE_MOVE_TO | Constant |
public static const WIDE_MOVE_TO:int = 4Specifies a "move to" drawing command, but uses two sets of coordinates (four values) instead of one set. This command allows you to switch between "move to" and "curve to" commands without changing the number of data values used per command. This command uses two sets in the data vector: one dummy location and one (x,y) location.
The WIDE_LINE_TO and WIDE_MOVE_TO command variants consume the same number of parameters
as does the CURVE_TO command.
See also
