FreeBSD supports EIDE, SATA, SCSI, and SAS drives (with a compatible controller; see the next section), and all drives using the original “Western Digital” interface (MFM, RLL, ESDI, and of course IDE). A few ESDI controllers that use proprietary interfaces may not work: stick to WD1002/3/6/7 interfaces and clones.
FreeBSD supports SCSI and QIC-36 (with a QIC-02 interface). This includes 8-mm (aka Exabyte) and DAT drives.
Some of the early 8-mm drives are not quite compatible with SCSI-2, and may not work well with FreeBSD.
FreeBSD supports SCSI changers using the ch(4) device and the chio(1) command. The details of how you actually control the changer can be found in the chio(1) manual page.
If you are not using AMANDA or some other product that already understands changers, remember that they only know how to move a tape from one point to another, so you need to keep track of which slot a tape is in, and which slot the tape currently in the drive needs to go back to.
Any SCSI drive connected to a supported controller is supported.
The following proprietary CD-ROM interfaces are also supported:
Mitsumi LU002 (8-bit), LU005 (16-bit) and FX001D (16-bit 2x Speed).
Sony CDU 31/33A
Sound Blaster Non-SCSI CD-ROM
Matsushita/Panasonic CD-ROM
ATAPI compatible IDE CD-ROMs
All non-SCSI cards are known to be extremely slow compared to SCSI drives, and some ATAPI CD-ROMs may not work.
The official FreeBSD CD-ROM ISO, and CD-ROMs from Daemon News and FreeBSD Mall, support booting directly from the CD.
FreeBSD supports any ATAPI-compatible IDE CD-R or CD-RW drive. See burncd(8) for details.
FreeBSD also supports any SCSI CD-R or CD-RW drives. Install and use the cdrecord command from the ports or packages system, and make sure that you have the pass device compiled in your kernel.
FreeBSD supports SCSI and ATAPI (IDE) Zip drives out of the box. SCSI ZIP drives can only be set to run at SCSI target IDs 5 or 6, but if your SCSI host adapter's BIOS supports it you can even boot from it. It is not clear which host adapters support booting from targets other than 0 or 1, so you will have to consult your adapter's documentation if you would like to use this feature.
FreeBSD also supports Parallel Port Zip Drives. Check that your kernel contains the scbus0, da0, ppbus0, and vp0 drivers (the GENERIC kernel contains everything except vp0). With all these drivers present, the Parallel Port drive should be available as /dev/da0s4. Disks can be mounted using mount /dev/da0s4 /mnt OR (for DOS disks) mount -t msdosfs /dev/da0s4 /mnt as appropriate.
Also check out the FAQ on removable drives later in this chapter, and the note on “formatting”in the Administration chapter.
They work. Most of these are SCSI devices, so they look like SCSI disks to FreeBSD. The IDE EZ looks like an IDE drive.
Make sure that any external units are powered on when booting the system.
To change the media while running, check out mount(8), umount(8), and camcontrol(8) (for SCSI devices) or atacontrol(8) (for IDE devices), plus the discussion on using removable drives later in the FAQ.