Brocade Fibre Channel Zone Driver

System requirements

Brocade Fibre Channel Zone Driver performs zoning operations via SSH. Configure Brocade Zone Driver and lookup service by specifying the following parameters:

Table 1.35. Description of configuration options for zoning_manager
Configuration option = Default value	Description
[fc-zone-manager]
brcd_sb_connector = cinder.zonemanager.drivers.brocade.brcd_fc_zone_client_cli.BrcdFCZoneClientCLI	(StrOpt) Southbound connector for zoning operation
fc_san_lookup_service = cinder.zonemanager.drivers.brocade.brcd_fc_san_lookup_service.BrcdFCSanLookupService	(StrOpt) FC San Lookup Service
zone_driver = cinder.zonemanager.drivers.brocade.brcd_fc_zone_driver.BrcdFCZoneDriver	(StrOpt) FC Zone Driver responsible for zone management

Configure SAN fabric parameters in the form of fabric groups as described in the example below:

Table 1.36. Description of configuration options for zoning_fabric
Configuration option = Default value	Description
[BRCD_FABRIC_EXAMPLE]
fc_fabric_address =	(StrOpt) Management IP of fabric
fc_fabric_password =	(StrOpt) Password for user
fc_fabric_port = 22	(IntOpt) Connecting port
fc_fabric_user =	(StrOpt) Fabric user ID
principal_switch_wwn = None	(StrOpt) Principal switch WWN of the fabric
zone_activate = True	(BoolOpt) overridden zoning activation state
zone_name_prefix = None	(StrOpt) overridden zone name prefix
zoning_policy = initiator-target	(StrOpt) overridden zoning policy

	Note
	Define a fabric group for each fabric using the fabric names used in `fc_fabric_names` configuration option as group name.

Questions? Discuss on ask.openstack.org
Found an error? Report a bug against this page

Legal notices